Turn the fan clutch counterclockwise and use a pulley wrench to keep the pulley from turning. An air hammer will make it easier to get off.
The clutch slave cylinder for a hydraulic clutch is inside the manual transmission bellhousing
Either the clutch master cylinder or the clutch slave cylinder or the clutch hydraulic lines are leaking.
It's the slave cylinder.
How do you change a fan clutch on a 1991 bmw528i?
Remove the radiator and take it to a radiator shop.
Answer: Normally located down by clutch arm (that sticks out between the engine and transmission). How do you locate it? The clutch pedal depresses a clutch master cylinder on the firewall (driver side). Follow the hose line down to the where the clutch arm is located. NOTE: don't get the brake master cylinder and clutch master cylinder confused, its easy if you do not work on cars regularly.
your slave cylinder is leaking,need to replace.
The slave cylinder for a hydraulic clutch on a Ford Ranger is inside the manual transmission bellhousing
The slave cylinder for your hydraulic clutch is located inside the transmission bell housing
It's going to look like your power brake reservoir. It is the reservoir for your clutch slave cylinder.
Four cylinder, under the housing where the upper radiator hose attaches. Six cylinder, under the housing where the lower radiator hose attaches to the engine.
The slave cylinder is inside the transmission on most models and can't be changed without first removing the tranny. It would be a wise decision to change the clutch at the same time as the job requires a lot of labor.