0
Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant frm the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Replace housing Re-fill coolant slowly to prevent an air lock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you change 1998 s10 oxygen sensors?
The oxygen sensors on a 1998 Chevrolet S10 are changed by disconnecting the lead wire and unscrewing them from the exhaust manifold. New sensors are then screwed into place and the wires reattached.
Do it yourself oil change on 1996 Chevrolet S10?
Yes, there is no reason you should not be able to change the oil by yourself in a 1996 Chevrolet S10.
Where is the coolant temperature sensor on a 1993 Chevrolet S10?
It is on the cylinder head near the thermostat housing.
What is the engine oil capacity in a 1998 Chevrolet S10 4.3L V6?
It should be 4 and 1/2 US Qts with filter change.
Where is the thermostat in a 2000 S10 Chevrolet?
I've got a better question, why is this question in the Chevy venture forum ?
Will atf plus 4 damage automatic transmission 1998 Chevrolet s10?
no it will not
Where is the thermostat housing location on a Chevrolet s-10 pickup with a 4 cylinder gas engine?
Uwhere is the thermostat located in a 1998 4.6 l s10 pick up truck? sually on the top front of the motor under the top radiator hose.
How do you change a master cylinder for a 1998 Chevy S10?
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
Location of 2001 Chevrolet S10 4.3 engine thermostat?
If you follow the upper radiator hose to the engine, the hose is attached to the thermostst housing. The thermostat is located under the thermostat housing.
Location of 1998 Chevrolet S10 4.3 engine thermostat?
Follow the upper radiator hose from the radiator towards the engine. The upper radiator hose is connected to the thermostat housing on the engine side. The thermostat is under/inside the thermostat housing. Remove the upper radiator hose from the housing then remove the two bolts holding down the thermostat housing then remove the thermostat housing to expose the thermostat.
Do you drain radiator to change thermostat on 2003 Chevy s10?
You need only to drain off a couple quarts of coolant to change the thermostat.
What if no spark 1993 Chevrolet S10 pick up?
change crank sencor
