answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-09-13 11:14:46

I've got a better question, why is this question in the Chevy venture forum ?

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


Get a Haynes repair manual for your 2000 Chevrolet S10. Covers most minor service questions like this. Any Autopart store. $17 or $20.


It is on the cylinder head near the thermostat housing.


If you follow the upper radiator hose to the engine, the hose is attached to the thermostst housing. The thermostat is located under the thermostat housing.


Remove 2 mounting bolts and replace



follow top radiator to end of hose, the thermostat is in the housing at end...


You did not mention the engine size. Regardless, it is in the thermostat housing on the intake manifold.


The thermostat is located on the engine of a 6.0 vortex 2000 Chevrolet Silverado 2500. The thermostat can be found by following the upper radiator hose directly to the thermostat.


The 2002 Chevrolet S10 was fuel injected.


did a 1984 Chevrolet s10 come with door speakers


on the water pump. follow the top hose from your radiator. it attaches to the block at the thermostat housing.


Underneath the thermostat housing just in front of the throttle body ! Follow the upper radiator hose to where it joins the engine , remove the two bolts and you will see it !


Get a Haynes repair manual for your 2000 Chevrolet S10. Covers most minor service questions like this. Any Autopart store. $17 or $20.


follow top radiater hose to it,it is hard to access housing!!! for thermostat, the thermostat is at the end of the lower intake manifold on drivers side of engine.


Could be low on coolant or a sticky thermostat.


go to http;//en.wikipedia.org/wiki/chevrolet s-10


Had a similar problem with a 2000 S10, went to dealer and they unlocked the radio.


Im in need of a 2000 S-10 engine wiring diagram


Changing the thermostat on a 2002 Chevrolet 4.8 liter engine is simple to do. First, follow the upper radiator hose to the thermostat. Then drain the radiator hose. After the hose is drained, remove the clamps and bolts holding the thermostat housing in place. Then remove the old thermostat and replace with a new one.


Follow the upper radiator hose from the radiator towards the engine. The upper radiator hose is connected to the thermostat housing on the engine side. The thermostat is under/inside the thermostat housing. Remove the upper radiator hose from the housing then remove the two bolts holding down the thermostat housing then remove the thermostat housing to expose the thermostat.


Yes, there is no reason you should not be able to change the oil by yourself in a 1996 Chevrolet S10.


The Chevrolet S10 doesn't have a timing belt.


No. The Chevrolet S10 series came out in the 1982 model year.


If you will follow the top radiator hose to the engine, you will see were it clamps to a housing. It is under that housing.




Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.