you must change the whole hub unit it's all pressed together
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Axle shaft u joint or the steering knuckle.
axle bearing or brakes or pinion bearing
Remove the caliper.Remover the brake rotor.Tap the axle free from the rotor.Then unbolt the bearing assembly from the backside of the bracket.
A 2001 Dodge truck does not have a speedometer cable. The speed signal comes from the rear axle speed sensor. (the sensor on top of the center of the rear axle)
175 ft lbs
If you do not change a bad wheel bearing the bearing will cut a groov in the axle.If it goes on long enough the axle will have to be replaced.It could also ruin the axle housing.Then you would have to replace the rearend.
Under rear, in front of back axle.
howdo you change the front axel of a dodge Dakota 2000 4x4
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearings.
The front axle nut would be a 35mm.
if you have to ask how to do this job, then it is beyond your ability. that bearing is pressed on the axle........