To change the lightbulb on a 2000 Odyssey: 1) Open hatch 2) There are two tabs on the brake light assembly inside of the hatch that you will need to open. 3) Remove two screws 4) Remove brake light assembly by pushing entire assembly towards back of vehicle. This is hard to do. Do not bend out to sides (this will break assembly) 5) Remove old bulb by turning counter clocwise. 6) Pull bulb straight out. 7) Reverse process to install.
fuse, bulbs, switch on brake pedal.
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.
How do you change brake pads for a 2000 Nissan Quest?
The left brake light works the right brake light doesn't and the bulbs is good
To change the back brake on the 2000 FXD kindly refer to your user manual.
Check fuse, check bulbs, check brake light switch, in that order.
If all the bulbs are good then it may be a blown fuse or a defective or mis-adjusted brake light switch.
Check the fuse, check the bulbs and check the brake light switch, in that order.
Pop the trunk, remove the "3 wingnuts" behind or on the carpet. That will in turn loosen the tail lights. Turn the bulb, and voila!
How do you change the front and rear brake pads on a 2000 Honda Civic Si?
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
change fronadst brake