Best Answer

Remove caliper and pull rotor off the hub. Push new one on, replace caliper and pads.

User Avatar

Wiki User

โˆ™ 2012-11-21 01:43:09
This answer is:
User Avatar
Study guides

Can slotted or drilled rotors be machined in a brake lathe

See all cards
2 Reviews

Add your answer:

Earn +20 pts
Q: How do you change front rotor 1995 Isuzu Rodeo?
Write your answer...
Still have questions?
magnify glass
Related questions

How to change the front rotor on Isuzu Rodeo 2001?


How do you replace a lug on the front rotor assembly of a 1995 Isuzu rodeo?

The old broken one must be driven out and the new one driven or pressed in.

Isuzu Rodeo rear rotor thickness?

The rear rotor thickness should be three quarters of an inch, when new. The rotor should not be reused when the thickness is less than one half inch.

Where is the emergency brake in the 2000 Isuzu Rodeo?

On the rear wheeels. some have a special drum inside the rotor and some use the caliper.

How do you remove front rotor on 2006 sprinter?

how to change rotor front disc on 2006 sprinter

When do you change front wheel bearings?

When you change rotor or main ball joint, or when they get worn.

How do you change front rotor on 2004 Trailblazer?

take off the tire and the caliper and the rotor just slides off

How do you change the front rotor on a 89 bronco2?"

What is the minimum thickness of a front disc rotor on a 1999 Isuzu NPR?

The Manufacturer specification lists the front rotors as 1.020" new, & 0.969" minimum (discard). A refinish minimum is 0.983"

How to fix Pulsing front disc brakes?

you have to change the rotor cuz the rotors slightly bent or its groover to bad and when u change the rotor change the pads as well on both sides

How change brake pads in Toyota Highlander 2005?

how do you change the front brake rotor on a 2001 highlander?

Why would the brakes groan and vibrate on an Isuzu Rodeo when braking the rotors have been turned and new pads installed but it still happens.?

Possible warped rotor. Turning rotors doesn't get rid of warp. Brake shop needs to check for this and replacement of rotor is cure for this problem

People also asked