To change the license plate lamp on a 1998 Bravada, locate the bulb. Visit an auto parts store to obtain the exact bulb and screw it in place.
yes the s10s were the same from 94 to 04 exept for the interior and grill change in 1997-1998
ON A 1998 SEDAN DEVILLE IT 'S COMPACITY IS 7.5 QUARTS SO I WOULD SAY MAYBE BETWEEN 6 - 7 QUARTS.
You will need a GOOD pitman arm puller.
Partner 1.9D 1993 to 1998. Recommended change intervals are. 72,000 miles under normal conditions. 60,000 miles under adverse conditions
You may need to remove the rubber sleeve to change the fuel pump, but vaseline on the ring will help it seal properly. You may need to drop the fuel tank before you begin.
same way you do
You can gain access from behind the bumper.
To change the license plate light on a 1998 Chevy Cavalier, reach up under the bumper and remove the bulb over the license plate. Then put a new bulb in the socket. The bulb can also be accessed by removing the lens on the outside, but there are screws to remove first.
rech behind the bumper and turn the bulb socket and pull it out !!!!
The size of the screw needed to mount a license plate on a 1998 Cadillac STS is 1/4-inch?æby 1/2-inch. They make license plate kits that includes all needed hardware.
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
The license plate bulb on a 1998 Buick LeSabre is replaced by removing the retaining screws and disconnecting the wiring harness. The bulb can then be twisted from the socket and a new bulb installed.
Bulb number 168.
Mine never came with one...
push up and turn on the housing
To reset the computer on a 1998 Bravada you need to disconnect the negative cable from the battery. Leave off for 10 minutes and reattach.
YEs 4.3L