You didn't say which engine you had, but with most of those GM's you had to roate the engine to get to the rear plugs. Lisle tool company sells an engine rotation tool. You disconnect the engine stuts that attach to the radiator support and install the turning tool in its place. You put the car in neutral and tighten the tool. That rotates the engine forward enough to get your hands back there to replace the plugs. If you want to play with cars, you have to own the tools.
where is the engine controle module located in a 1995 buick lesabre
If that Buick has the 17 digit vin, the 8th digit would be the engine code.
The starter for the 89 buick is located in the front of the engine under the exuast manifold... Can be accessed from underneath the car.. will need to jack the car up somewhat to get to it.
You can replace your 1998 Buick 3.8 liter engine with a Buick 3.1 liter engine. You will need to change the motor mounts and some of the wiring harness will need to be modified.
under the front of the engine about center of the engine. hope this helps
On a 1993 buick regal it is on the side of the radiator.
The coils are mounted to it.
On the RF of the engine underneath.
The 1994 Buick engine control computer is located behind the passenger side dashboard. You will need to remove the glovebox in order to access the computer.
The crankshaft position sensor, on your 1992 Buick regal 3.1 liter, is located on the back of the engine. The crankshaft position sensor is on the inside of the engine cover.
The oil sending unit for a 1998 Buick Ultra is located on the front of the engine, below the power steering unit. Remove the plug from the sensor, and unscrew it from the block to remove and replace it.
The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.