answersLogoWhite

0


Best Answer

open the plastic part up there is a battery inside find the right kind of battery, I got mine at radio shack for 11.00. Put the battery in, place plastic pieces back together. check to see if it works

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the battery in a lighted ignition key on 1990 325i?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the ignition switch on a 1990 Cadillac DeVille?

Take it to a shop


What is the problem with an 1990 corvette the engine will not turn over or start when ignition turned on?

check the battery and connections/cables


How do you change a battery in a 1990 Cadillac Brougham?

you remove the battery hold down brace and voala! its done!


What causes the ignition light on your 1990 Fiesta to come on when the engine is switched off even with keys removed from ignition?

check for a bad earth strap going t gearbox to battery


What causes no spark in 1990 Ford Tempo?

Faulty Ignition System. Dead battery. Dead Coil. Worn out Ignition "Wires" to Plugs. Corroded Battery Cable to Starter. Corrosion at Battery Terminals. Engine Ground Problem thereof eliminating complete Electrical Circuit. Blown Fuses or Relays. Faulty Ignition Switch. Hope one of these is it!! CHEERS!!


How do you change an ignition switch on a 1990 Cadallic?

you have to go under the dash and take out the steering column. and the ignition switch should have a wire going down to the bottom of the column coming from the ignition lock.


The ignition in your 1990 bronco wont engage the starter and causea the battery power to remain on already changed the lock cylinder without result?

the ignition actuator is broken, you can turn off the "battery power" by the the ignition actuator rod that leads to the ignition switch, it runs along the top of the steering column under the dash, locate it and pull it towards the steering wheel, this should shut off the power. or you can unhook you battery, but either way you will have to replace the actuator.


Where is the ignition control module on your 1990 Chevy k2500 pickup?

it's underneath the rotor in the distributor. you have to take the distributor out to change it.


How do you change the ignition switch in a 1990 Pontiac Grand Prix without pulling the steering column?

the ign switch or the key & tumbler ???


Your 1990 Ford Ranger seems to have power to the fuel injectors and fuel pump when the ignition is turned off This runs the battery down The truck starts ok when the battery is charged and runs ok?

have starter motor checked. ford starters will run a battery down when swithed off if they are worn out.also check ignition switch Check the fuel pump relay. It may be sticking.


How do you replace a 1990 Chevy Beretta battery?

how to replace a 1990 Chevy Beretta battery


1990 Chrysler new yorker 5th ave battery was dead then I charged the battery now will not idle?

Change idle speed contol sensor Uncool the battery for five minutes to reset the computer.