what model 806 do you have? If the clock is in front of the rear view mirror,follow these steps. prise off the maplight cover and the cover over the light switches. Underneath you'll find 4 largish star screws. Undo these freeing the whole unit (theres a lug near the widscreen you'll have push the unit over this. locate the clock unit,undo the 2 small star screws and you'll find the bulb holder.They accept the small stubby bulbs same as the main dash panel. If you need any more advice,just send me an e-mail to ianmutch1963@Yahoo.co.uk as removing the dash panel is a bit long winded. Hope that helps Ian
How do you tune in the radio on a Peugeot 107 Active
You can set or adjust the clock on a Peugeot Boxer van by pushing on the little buttons below the clock using a pen point.
If you clock does not work in your Peugeot 206 when the stereo is plugged in, check the clock fuse. You should also ensure you do not have a wiring problem.
remove lower plastic panel covering clock, hazards etc carefully with flat butternife type instrament (not to mark plastic to reveal 2 torx screws remove these, undo wiring connector twist the 2 black bulb holders from the back and replace bulbs reffiting is reverse of removal
Change all the bulbs on the car, the radio, clock, battery, starter, and generator or alternator.
brighten
how do you change des board lights end lights on clock on a vauxhall Astra 1.6ls year 2000 w reg
hold down the trip reset button for about 10 seconds then the minute hand should start moving
remove trim, remove clock, remove clock light harness, and remove and replace clock light bulbs
This answers is accredited with thanks to golfguy at http://www.206info.co.uk/ForumsPro/viewtopic/t=19256/highlight=clock+bulbs+chang%2A.htmldead easy!1/ Push backwards on the cover over your clock - this will pop out towards the windscreen.2/ You will now be able to see your clock. look for a Trox screw in front of the clock - remove this and you will be able to lift the clock unit out (can be done with a normal flat head screwdriver).3/ Disconnect the wiring on the back.4/ Twist the bulb on the back of the clock unit 90 degrees, and the bulb will pop out.5/ The bulbs are roughly a quid in your local motabitz or wherever, pull the old one out of the casing and put the new one in.6/ Repeat as necessary and reassemble.Done!Also...The cover comes up and out complete with the hazard warning button. No need to disconnect this.The clock unit takes 3 bulbs.They are a push fit into the white bayonet plastic bolder and old ones can difficult to remove.Make sure new bulbs have wires making contact with holder.You will need to reset the clock unit language and date/time when you reconnect it.Good luck!
t5 bulb
If you mean the lights behind the clock and the climate controls, they are T05.You will find all types of lights used in your Peougeot 206 in this site: http://206gti.net/lightsThere are also tutorials on that site on how to replace the bulbs.