You have to pull the balancer and then you have 2 screws holding the crank sensor to the engine block.You will need a puller with 3 small fingers to get the balancer off.Be careful not to bend the tangs on the rear of the balancer.
Check
To change the fuel level sensor in a 2000 Chevy Impala, first close the gas and power lines. Remove the wiring and then drop the car tank. Remove the old fuel level sensor and replace it with the new one.
The crankshaft position sensor can be found on the bottom of the engine in a 2000 Honda Civic EX. It is next to the crankshaft itself.
The crankshaft sensor for this model is located at the front of the engine, near the crankshaft itself.
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
AFAIK no, you just need to do the crankshaft variation learn. If you don't have a scan tool with the required functionality, you will have to visit a mechanic.
I had a problem with stalling with a 2000 Impala, and it was the oxygen sensor.
Took me about an hour to change mine, but it was the first time.
The rear crankshaft sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order for the sensor to be visible.
near the crankshaft
you have to separate the engine and tranny to have access!! very labor intensive
The 2000 Mercedes-Benz E3 20 crankshaft position in sensor is located on the back of the crankshaft. You will need to remove the rear engine cover in order to see the sensor.