Roughly 4.5 quarts with a filter change.
The 1989 Pontiac Firebird oil sending unit is located on the bottom of the engine. You will need to remove the oil pan in order to access the oil sending unit.
4.5 quarts with a filter change
Hold the oil/trip Reset button while ignition is on (not car) for 8 seconds
All car engines have an oil pump.
About 4 and a half quarts
10w30 motor oil should work nice
The 1995 Pontiac Firebird V-6 engine oil pump is located on the bottom of the engine. The oil pan will need to be removed in order to see the oil pump.
Someone put it there.
either 5w30 or 10w30 will work well.
left hand side of motor on side of oil pan
The check gages light on the Pontiac Firebird Trans Am means to check temperature, low oil possibly, water. These are to be kept maintained for the car to run properly.
I use 10W-30
5 and 1/2
Begin by removing the oil from your oil pan. Remove the oil pan retaining bolts. Put a new gasket on your new oil pan and reverse the process.
the owners amnual recomends 10w 30
No you do not , But it's one hell of a job to get off.
for my 1974 firebird 5.7L 350, it is the oil filter mounting bracket (aka the housing the oil filter goes into)
The EGR Valve on a 1999 Pontiac Firebird is located just to the left of the engine oil dipstick. There's nothing in the way so it's pretty easy to get to and replace. Hope this helps! -Erin
Turn the ignition on in the car and hold down the trip reset button on the dash for about 10 seconds, the change oil light may blink a few times but then go out. All done!
Six quarts of oil are needed to change the oil on a 1992 Jeep Wrangler.
5 qts. with a new oil filter change.
i have a 99 gtp and it resets itself after i change the oil
Loook in your owners manual, I use syntheric blend 20w50