First jack the front of the vehicle up and support it securely on jack stands(make sure you push on the car a few times after you put the jack stands under it to be sure it is securely support before you crawl under it).Next disconnect the positive battery terminal from the battery.Now with you shop light get under the vehicle,the start should be on the passenger side of you vehicle,near where the motor and transmission connect.Disconnect the wires going to the starter making sure you label them to make reinstallation easier.Now take out the two bolts the hold the starter in place making sure to support the starter before you pull out the last bolt so it doesn't drop on your head.Installation is the reverse of removal. you out.
29s, i replaced the oil pressure sender on my 92 corsica 3.1 and i did it while having my starter changed because it is located directly above the starter on the engine block.
The starter solenoid is located on the starter. It would be more cost-effective to have the entire starter replaced with a good remanufactured unit on this application.
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
In the exhaust system before the catalytic converter.
im sure it is, and i doubt its worth it.
passengers side top (relays)
Run a new one from the blower motor body to ground
most ive seen is in the truck.or under the dash on the passenger side. Jessie
Remove the positive cable from your 1992 Chevy Lumina battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Could be your crank sensor. These are very common to fail on these cars.
Leak in heater core
The '92 Corsica's are still OBD-I , so the CanOBD2 is only going to work on Corsica's 1996 and newer.