Trade it in for a Holden
Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly
You don't let some else do it. I say this from experience on a 2004 The motor is separate I used the old motor and replaced the regulator. I had to drill out rivets OH ya I BROKE the window drilling out the rivets that hold the window onto the regulator. after that I reattached the motor assembly with bolts and nylon lock nuts. then went to a glass shop to have the window replaced.
Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.
How to remove the window motor from the regulator
Window motor and regulator are found inside of the door panel and may be bolted or riveted in. Should be bolted. Disconnect the window from regulator, take out reg. and motor, then disconnect regulator from motor, reconnect new motor to regulator, reattach those inside of the door, then reconnect the window to the regulator, put it together and see if it works.
probably window regulator
window regulator cable is broken need new regulator
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
Try this link, http://www.a1electric.com/grandam.htm. It shows how to replace the entire window regulator assembly (which includes the motor). Probably the cleanest description I have found.
Probably the the motor/regulator assembly. I was able to pull mine up with my hands then tape it up. A new motor/regulator cost me $300.
You have to drill the rivets on the motor separating it from the regulator. The new motor then mounts to the regulator and you insert the new bolts where the riverts were.
You will have to replace the entire regulator assembly. The wire is not available.