How do you check your 2000 tiburon transmission fluid for a manual?

Answer 1

well jack up the car to get to plug on side of transmission at least a 17mm head on this bolt break it lose then get out from under car let car down reach up in there now that it is finger loose u can remove plug , note : place a pan under in case it is already still full , with car on level ground it should be full when there is some fluid that is still running out of drain hole. proper level is fill it at drain hole until it starts dripping back out ,lets stop dripping then double check by adding until it starts dripping again. then install drain plug to factory tightening spec ( good and tight but not to tight to stripe the plug ) there is a crush washer so be sure to replace with new before reinstalling plug this helps seal and crushes before striping of the drain hole occurs .... have fun and good luck