Check under both front seats for a yellow wire. The airbag wire can become severed over time.
Mechanics will try to charge you up to $1000 to fix this. You will be able to fix this yourself if you are able to reattach the wire. At the very least, you can tell your mechanic that you found the severed wire and save yourself some serious money.
Check with dealer to see if your car falls within the recall type campaign on that light. You may be able to get it fixed for free even if it is out of warranty.
I have had the same problem with my 2000 Beetle. The only way to reset is to have the dealer do it. so far they have replaces the wiring harness in the drivers seat for the side airbags and several other components under the drivers seat. It seems to be a problem only when the seat is moved. One mechanic says the seat is moved too much( that is crazy i think) I realize it sounds a bit nuts but i have been dealing with the airbag light in and out of the dealer since I purchased it in 2003. Good luck with that one. If the light is on it will not pass a safety for resale. I would suggest trade it in you will get no where with Volkswagen.
The airbag light stays on when there is a malfunction in the system. The airbag computer will need scanned to know possible causes.
In order to get your SRS Service Airbag light reset, You have to go to the Volvo dealership.
At the dash board manometer.
The airbag light stays on when the computer has detected a malfunction and set a code. Clearing the code with out repairing the failure will not shut the light off.
The fuse for the airbag light on a 2000 F150 is under the dash. The fuse box is located under the driver's dash.
The airbag computer has detected a malfunction. You need to have the system checked for codes to know possible causes.
H1 55W bulb
Your a6 needs to go to the dealer for a new Audi a6 airbag. Maybe there was a recall.
Where is the airbag module on the 2000. Ford expedition
If an airbag light came on after taking off and replacing a steering wheel, the person needs to make sure the steering wheel is on correctly. Otherwise, to reset the light a person can use the OBDii scanner and clear the light.