DO NOT go putting wires into your fuse box, this could cause problems in the future, if you have a power Antenna wire on the back for your radio, [Blue in Most cars, but refer to your cars manual.] Splice the REMOTE wire from your amp into the Power antenna wire OR if you dont have a power antenna wire. if your car has RAP [Retained accessory power, or your radio doesnt turn off until you open a door] its a good idea to use a 12V Accessory wire. any more questions just email me.
Note : Many head units will only energize the power antenna wire when the radio is on and then deenergize it when you switch to cd. So your best bet is to just go with the accessory wire method described above.
all I need is what the color codes from the stock wire harnes to connect to the new one
The wattage of your stock stereo in your 1989 Acura Integra is 75 watts. There was anÊoption for a larger stereo output of up to 200 watts.
it depends if u are using the stock stereo then no but if it is not a stock stereo then u may have an aux input jack which comes out the back of the stereo the easiest way is to just pull out the stereo and take a look
on mine i had a premium sound system package stock. i had to bypass the stock amp to run the head unit even though i am running it on the pre amp from the head unit. the speaker will notwork unless you bypass the the stock amp.
Yes you can. First, determine which type of signal input is required by your amplifier, RCA inputs or (+/-) speaker wire. If it's only RCA inputs and your stock stereo does not have RCA outputs in the rear of the unit, then you will have to convert each speaker wire pairs to RCA with a converter, then go to your amplifier. If your stock unit does have RCA out, then just use an RCA cable and connect the signal from your stereo to your amplifier. Then simply follow the instructions from your amplifier to connect your speakers depending on if they are 2ohm, 4ohm, or 8ohm, etc. PS - make sure you properly ground your amplifier to either chassis or directly to the negative on your battery. If you create any large amounts of resistance or have extra wire hanging around, you will get ground loops and EMI problems and hear engine noise from your speakers as you accelerate. Good Luck
To get any replacement battery for a keyless entry system you have 2 options, 1: Contact the dealer they carry these batterys in stock at most locations and 2: most aftermarket car stereo/security shops will have factory replacement batterys in stock
screwdriver, and then pull hard enough to rip out the wires and then there you have it. the way to remove a stock stereo the theft version
call the dealer, give them the vin number and tell them that you iether just purchased the car or had your battery changed and they will give you the stock code
NO there is not.
because the stock stereo sends a signal to the stock factory amplifier, removing the stereo has probably left the amplifier in a constant on mode therefore it is always drawing power. you can check this once you find the amp . on the wagon it is located in the bck drivers corner behind where the cd changer goes.
Yes, there is a wiring diagram fro the stock stereo for the 1993 Lincoln Continental. This can be find in the maintenance manual.
I do not believe it is. I know the stock stereo from the 2006 Mazda 3 does not support mp3 cds.