answersLogoWhite

0


Best Answer

Ford manufactured vehicles use a specialty tool to connect/disconnect air conditioning lines. Check with your local auto parts retailer. They usually have a plastic set that works adequately for occasional use, and is reasonably priced.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you disconnect the air conditioning lines 1995 Grand Marquis?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where are the vacuum lines on a 1992 Grand Marquis?

Try to be more specific. They are all over the car.


Were is fuel pressure regulator on 2002 grand marquis?

It's on the end of the fuel rail near where the fuel lines attach.


How do you disconnect air conditioning lines on dodge 97 pickup?

You need to buy an a/c spring lock coupler line disconnect set at any auto parts store and they come in a set of (4)..........


How do you remove the ac compressor on 97 mercury grand marquis?

loosen belt remove wiring plugs remove part that has the metal tube going to it. It will leak freon if your system is full there are 4 bolts on the front of the compressor connecting it to the engine, remove them. lift compressor out. this is from the top of my head, so sorry if it isn't exact, but will give you an idea. takes about an hour to change for the average person with proper tools.


How do you unclog my cars ac lines?

You can unclog your cars air conditioning lines by disconnecting the lines and blowing air through them. It may be just as easy to purchase air conditioning lines.


Is there a fuel line replacement kit for a 1989 Mercury Grand Marquis for sale or do new lines have to be fabricated?

generally fuel lines, other than those attached to fuel filter with special connectors, need to be fabbed on the vehicle.


Why does my 97 merc grand marquis not idle some mornings unless i keep my foot on the gas pedal?

your loosing idle pressure check your vacume lines ans throttle sensor


Where is the fuel pump relay on a 1985 Mercury Grand Marquis LS?

The fuel pump should b on the fuel lines or it will sit on top of the fuel tank if so you will have to remove the fuel tank...


How do you remove the air conditioning compressor on a 1994 olds cutlass supreme?

first remove the belt via the belt tensioner use a 3/4 wrench to do so disconnect all lines and hoses and unbolt it for engine


Is dripping air conditioning condensate lines normal?

yes


Install a new starter in 2000 grand marquise?

I'm assuming you mean how do you remove a starter in a 2000 Gran Marquis? 1. Disconnect the battery ground cable. 2. Raise and support the vehicle. 3. Remove the starter motor solenoid terminal cover. 4. Remove the bolt and position the transmission cooler lines and bracket out of the way. 5. Remove the red protective cap on the starter solenoid. 6. Remove the nut and disconnect the wire. 7. Remove the nut and disconnect the wire. 8. Remove the three bolts. 9. Remove the starter motor .


How do you replace the heater core on a 2005 dodge ram 1500?

Disconnect the negative battery cable.Discharge and recover the air conditioning system refrigerant.Disconnect the refrigerant lines from the evaporator. Plug the openings to prevent contamination.Disconnect the refrigerant lines from the accumulator. Plug the openings to prevent contamination.Remove the accumulator.Drain the cooling system into a clean container for reuse.Disconnect the heater hoses from the heater core tubes.Remove the PCM from the dash panel and move it aside. Do not disconnect the PCM harness connector.In the engine compartment, remove the heater/air conditioning housing assembly-to-chassis nuts.In the passenger-s compartment, remove the heater/air conditioning housing-to-dash panel nuts.Pull the heater/air conditioning housing assembly rearward far enough to clear the studs and air conditioning drain tube holes.Remove the heater/air conditioning housing assembly from the vehicle.Remove the upper-to-lower heater/air conditioning housing screws and remove the upper housing.Remove the heater core from the lower housing.