This may be a simple anwer, but you just unplug it. It is a locking connector, so you have to figure out where to push to unlock it, but it should not be too difficult. The connector is typically locked onto the housing of the fan assembly.
REMOVAL 1. Disconnect the negative terminal connnection on your battery. 2. Locate your starter and disconnect the electrical connectors. 3. Remove the starter bolts. INSTALLATION Reverse of removal instructions. Hope this helps
water got into electrical connectors and or fuse box shorting them out
Disconnect the negative battery cable. Remove the air cleaner assembly if necessary. Disconnect the electrical connectors from the alternator. Loosen the alternator adjusting bolt or nut and through-bolt and remove the alternator belt. Remove the alternator adjusting bolt or nut and through-bolt and remove the alternator. If necessary, remove the mount bracket bolts and the upper and lower mount brackets. Installation is the reverse of the removal procedure: put the alternator in place and re-bolt mount bracket (if removed). Engage the electrical connectors and install the air cleaner assembly (if removed).
It can be very simple to remove the radiator from a Honda Civic. The first step is to drain the coolant from the radiator. The next step is to disconnect the cooling fan switch and remove the hoses. Then the cooling fan should be removed. Then the radiator should be unbolted and lifted carefully from the vehicle.
where is the cooling sensor Honda accord 1992
You can get a diagram of your 1987 Honda Accord cooling system at most Honda dealerships. Honda service manuals will also have the cooling system diagram and can be obtained from most local libraries.
It is either one of your electric parts gone out such as CDI or the coil but my 2002 honda rancher 350 wouldn't fire and I sprayed WD-40 on the electrical connectors and then it started to fire. If you have been in lots of mud this might have been caused. Make sure the switch is off when unplugging the wires (Honda electrical system is very sensitive).
To change Honda jazz cigarette lighter socket fuse you need to disconnect the 2P connectors from the cigarette lighter (A) and cigarette lighter light (B) (if equipped).Inspect the connector terminals to be sure they are all making good contact.
A working cooling fan is important in keeping the engine of a car running well. A diagram for a cooling fan in a Honda Accord can be found in its maintenance manual.
Honda-CB.com has a diagram with the connectors color coded.
how do i disconnect a car alarm wire that runs to the batter form a 1996 Honda accord ex
After you remove the center console, you can reach around the back of the dash and disconnect the power cable to the socket, then hold the "nut" on the back of the socket and unscrew the socket.