Ford Windstar
Ford Explorer
Ford Expedition XLT

How do you do Fuel Pressure Release Procedure on Ford Windstar fuel line?

242526

Top Answer
User Avatar
Wiki User
2015-07-15 18:54:47
2015-07-15 18:54:47

All you have to do is make sure engine and fuel pump is not on. Then open up the gas cap. That will remove the pressure inside tank and fuel line. There will still a little fuel left in lines when disconnected so be careful. Next time fuel pump comes on it will force all air from lines when cranking engine.

{added on 11/23/2008}:

Most fuel injected engines will still have pressure in the fuel lines even after doing this. To relieve this remaining pressure, all you have to do is find the Pressure Relief Valve on the fuel rail on the engine itself. It looks just like the valve stem on a tire. Simply use something (preferably the proper tool) to release the remaining pressure in the fuel lines the same as you would release pressure in a tire. Please be careful to not get any fuel spray in your eyes or face.

disconnect the fuel pump relay , refer to your owners manual for realy box location on the van

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

There is no fuel pressure sensor.

User Avatar

The pressure switch for the air conditioning system on a 1996 Ford Windstar is located in the accumulator. It triggers when the compressor will turn on and off.

User Avatar

That's your LOW tire pressure warning light in a 2002 Ford Windstar

User Avatar

Contact the dealer, There is a certain procedure you have to go through.

User Avatar

On a 1996 Ford Windstar : No , just the LOW oil pressure warning light in the left side of your gauge cluster

User Avatar

Ford Windstar was created in 1994.

User Avatar

On a 1996 Ford Windstar : Under the dash on the drivers side , not too far from the inside hood release

User Avatar

The fuel pump reset button on a 2003 Ford Windstar is on the driver's left foot area. It is next to the hood release.

User Avatar

Yes. The mirror on the 2001 Ford Windstar is the same mirror found on the 1999 Ford Windstar. They are interchangeable.

User Avatar

There is no inside "trunk" - rear hatch release button on the Windstar.The only way to open it is at the rear hatch itself.

User Avatar

Replace the oxygen sensor behind the engine - grey connector.

User Avatar

ford windstar van will not start or have lights in dash

User Avatar

The oil pressure switch is right under the alternator bracket or power steering pump

User Avatar

Replace freeze plug in a 1998 ford windstar ?

User Avatar

The battery group is 65N for a 2003 Ford Windstar

User Avatar

How many tons does a ford windstar van weigh

User Avatar

The CD changer is in the center console of a 1999 Ford Windstar

User Avatar

Do you have a 3.8 engine for a 2001 Windstar Ford Van?

User Avatar

remove the alternator and bracket it is under the bracket

User Avatar

I believe the descriptor is: Evap Low Pressure (related to fuel tank)

User Avatar

With AC pressure gauges and manifold assembly. This is best done by a professional.

User Avatar

There is no "Winstar" - that is simply people leaving out the 'd' when spelling WinDstar

User Avatar

The 2001 3.8L Ford Windstar has a timing chain, not a belt.

User Avatar

A 1998 Ford Windstar would use refrigerant 134a


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.