Mitsubishi Mirage
Nissan Pathfinder
Ford E-350 Van
Turn Signals and Hazard Lights

How do you fix a dim blinker light on a 98 mirage?

515253

Top Answer
User Avatar
Wiki User
2006-11-18 02:18:27
2006-11-18 02:18:27

if buying a new light bulb, fuse, and relay dosent work, make sure that the wire that goes to the harness on the bulb is in all the way. just pull on the wire alittle bit. not to hard. if one of the wires comes out put it back in and move it around. the light should brighten, buy a replacemtn conecter tip like the one on the wire. crimp it on and plug it in. that should fix it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Replace the tail light bulb from inside the trunk after pulling back the carpet. This should probably fix your blinker too.

User Avatar

In order to fix a Mitsubishi mirage signal light that doesn't turn off, you would need to understand the wiring system. This is a problem with the wiring and the circuit that connects the power from the battery to the signal light.

User Avatar

Repair whatever is ailing the engine. That light is telling you something, have the codes read and find out what it is and repair it.

User Avatar

i have a 1990 Toyota corolla and my blinker wont turn left or right on its own I have to do it manualy i think its been cut off what do i need to buy to fix the problem

User Avatar

The blinker relay is broken. It is located inside the hazard switch. Replace the switch and it will fix your problem.

User Avatar

Need to find out what is causing it to stay on and fix it. Once fixed, disconnect the battery cables and let it sit for 30 minutes.

User Avatar

my opel astra leften side dim light is not working,i have tried so many times to fix it but i failed,what might be the problem?

User Avatar

Hmmm, kind of unusual because the same bulb filament serves BOTH the blinker and the brake function. It could be a short in the wire from the brake switch leading back to that particular bulb and if the left brake light work okay it would have to be somewhere AFTER the wires leading to the rear lights branch off from one another. Are you CERTAIN that the right rear signal blinker DOES work?

User Avatar

Turn you high beams on and check your tail light. If its brighter, you have a head light bulb as a tail light bulb. 97-02 are the only ones that should do this. Find a tail light bulb and replace.(I couldn't believe it either).

User Avatar

well i bought new lights for my instrument cluster thinking it would fix the problem but there still dim

User Avatar

If the blinker is not working on a Mazda 121, check the turn signal flasher. If the bulb needs to be replaced, remove the lens cover and insert a new bulb.

User Avatar

AnswerTo fix it do this : say the drivers side blinker goes on and does not flash. Well then you have either the front or rear blinker burned out. Thx KBThere's the possibility of burned bulbs, but if both sides fail to blink, replace the flasher unit.

User Avatar

Your screen goes dim because all the energy from the battery in the charger goes into you're laptop so when you unplug it. It goes dim but there is ways you can fix it that how my laptop works.

User Avatar

switch is bad DON'T ALWAYS LISTEN TO MECHANICS, YOU CAN FIX IT YOURSELF. The contacts from your blinker switch are dirty. Here is a forum that tells you exactly how to clean it http://www.grandamgt.com/forum/showthread.php?t=50126&highlight=clicking+signal+light

User Avatar

The oil pressure light is on due to the fact that there is no pressure from the oil, fill it up, and if that does not fix it, check for faulty wiring. P.S. There is no such thing as "Blinker Fluid."

User Avatar

sounds like a turn signal switch is shorted

User Avatar

more than likely one of ur bulbs are out like blinker bulbs in front or rearor sometimes a brake light its happen to me

User Avatar

Is the bulb burnt out? Change the bulb and it will blink at the dash and light. If it still doesn't work, check the turn signal relay.

User Avatar

Simply look behind the light (from inside the trunk or under the hood), and you access the bulb from their. turn the backing of the bulb to release it and simply change the bulb. A simple fix.

User Avatar

foglights work.dr side headlight works on bright but no dim. pass side bright gets dim.

User Avatar

you do not fix the light. you fix what ever caused the light to come on. so the lenght of time depends on the cause for the light to go on on the first place.

User Avatar

Have you checked the spark plug wire for that cylinder,??????????


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.