you need the key to fix it.
Remove the lock, take the cylinder out then replace with the correct bottom pins so they suit the key. Common cause of this fault is when someone does not cut a key properly or is an older key that has worn down over time
Don't know...but there are problems with the ignition lock tumblers wearing. Quick fix for a stuck key is to tap the lock while trying to turn the key. This will allow tumblers to fall into place so the key will turn. This fix will get you home, but not fix the problem. To fix permanently, disconnect power to car, remove dash trim below the steering wheel and remove enough screws to lift upper dash around steering wheel to expose key lock. Turn key to on position and depress tab in lock cylinder collar and pull lock cylinder and key out of car. Take lock cylinder to locksmith for new tumblers ( it cost me $12). Replace lock cylinder and put dash back together.
key
If you are talking about the ignition lock cylinder, the steering wheel must be removed and the column disassembled to access a lock screw which holds the ignition lock cylinder in the column. No key is required for this (unlike all other vehicle manufactures). If you are talking about the door lock cylinder, the door panel must be removed, and the lock cylinder retaining clip must be removed (again no key is needed, which is the same for all manufacturers). If you are talking about the trunk lock cylinder, it is easily accessible from inside the trunk. Those are the only types of lock cylinders in this type of vehicle. There is no specific lock cylinder named key lock cylinder.
that is the key code for that particular type of lock or cylinder. So if you see that code on the cylinder lock that is the key for it.
Removing a ignition lock cylinder from a 2002 ford windstar with no key
Lock cylinder must match the key for security system to work
You can have a locksmith do this for you. These professionals know how to make a key for any key slot.
You will find the key code on the drivers door lock cylinder. Must remove the whole lock cylinder to read the code. You will find the key code on the drivers door lock cylinder. Must remove the whole lock cylinder to read the code. Go to the dealership and give them the VIN number. They will be able to make a new key right there based on the VIN.
this is caused by ignition lock cylinder failure, you will have to replace the ignition lock cylinder and key.
Take out one of the key barrels - from either doors or trunk lid and you should find it on the lock cylinder itself.
The wires on the lock cylinder are broken-needs new lock cylinder./