Want this question answered?
The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.
Remove the intake manifold and take it to a welding shop that works with aluminum. Let them determine if it can be saved or not.
Need to know if it is the intake manifold or an exhaust manifold and what is wrong with it.
By replacing the whole gasket.
To remove the intake manifold on a 2004 Mitsubishi endeavor, you should take it to a mechanic. An authorized dealer will also fix it for you.
The spi Split Port Induction intake manifold will have to be replaced.
The connector into the intake manifold of a GM 305 and 350 has been known to be quite fragile. If the connector has broken you have little choice but to replace the manifold.
Different cars throw the same code for different faults. But the generic P1101 is MAF sensor, Mass air Flow. It is in line in the air intake between the filter and throttle body, and measures the amount of air entering the intake manifold and is part of what adjusts the fuel/air trim.
It is your Idle Airflow Censor. It is located behind your air intake manifold by two screws. Take it out and clean it off and it will fix your problem.
Replace idle air control valve. 2 10mm bolts and about 15 min. $100.00 at mazda.
on top of the engine block under the intake manifold. it can be accessed without removing the manifold. easy fix!
Have the intake air temp. sensor checked .Two wired plug on top of intake manifold. Check fuel pump pressure.