Radiators
Chevy Corsica
1995-1999 Dodge & Plymouth Neons

How do you fix a plastic radiator for a 1995 Chevy Corsica?

112113114

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 18:52:13
2015-07-15 18:52:13
A two part epoxy for $3.00 should do the trick, just follow the directions. I did mine two years ago and I run antifreeze/coolant.See: http://www.urethanesupply.com/radiator.html

I have a crack in mine as well with a slow leak, my mechanic on a Cadillac had the same problem and had to be replaced. If you have a better answer let me know. FYI I did find one on

http://www.partstrain.com/products/Radiator/1995~Chevrolet~CORSICA.htm

for $119.00 plus a little freight

I went to a radiator shop and they have a proses they use to fix them i got mine done for $50.00

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


where would i locate the fuse for the fuel pump on a 1995 Chevy corsica



A Haynes or chiltons manual has the how to. Or do a search for a forum for Chevy corsica specific


Because its a Chevy corsica not a ford corsica!!!!!



The side view mirror on a 1995 Chevy Corsica is mounted by screws. Remove the screws and panel for the mirror on the inside of the vehicle. Pull and replace the unit.



Under dash, near firewall, passenger side.


I find that Autozone is very helpful in answering automotive questions.


Check out the top of the fuel tank and the tubes leading to it.


Place a drip pan beneath your 1995 Chevy Corsica oil pan. Remove the oil pan plug. Allow the oil to completely drained out. Replace the oil pan plug to its original position. Fill the motor with oil.


It should be located just below the lower radiator hose.


you need to remove the taillight assembly. you will see all the bulbs.


It is located in the front of the motor just above the starter.


The spindle is what the front wheel is mounted on. It is the shaft that the wheel bearing slides up on.


Listed in your owner's manaul and on the driver's door post. If not there, go to www.tirerack.com.


Remove the bottom radiator hose from your 1995 Chevy Lumina radiator. Put a water hose in the top of the radiator. Allow the water hose to run. Keep the water running until clear water runs out of the bottom of the radiator.



Look at the pulleys on your accessories. it's that rubber loop going around all.


fill the radiator to the top with 50/50 water and antafrezz


ON THE BLOCK. FOLLOW THE TOP RADIATOR HOSE, GOES FROM THE RADIATOR TO THE THERMOSTAT HOUSING. TWO BOLTS


Remove the bottom hose from your 1995 Chevy Corvette radiator. Allow the coolant to drain out. Put a hose into the top of the radiator. Run water through the radiator until it runs clear.


A used head gasket is not worth anything, because it cannot be reused.


Follow the upper radiator hose to the engine. It is behind there.


You can replace your 1995 Chevy Corsica motor mount by loosening the motor mount retaining bolt. Jack the engine up approximately 3 inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.