Auto Parts and Repairs
Electric Windows
Nissan Maxima
Ford Explorer XLT

How do you fix a window that will not roll down on a 92 Nissan Maxima?


Top Answer
User Avatar
Wiki User
2015-07-15 19:23:35
2015-07-15 19:23:35

If electric, take it to a garage or trim shop and have it checked out.


Related Questions

All the models that are double cab have a roll down back window.

The directions are in your manual. Roll the window down, roll the window up, release the button then hold it up for two seconds, roll the window down, release the button then hold it down for two seconds. Repeat that for each window.

Roll down the window...:)

1999 Pontiac motana mini van driver window will roll down but will not roll up ??????

The window is jamed, or your wires connecting your button to the window or busted.

73 nova is the only nova were the back window rolls down

roll the window down and relax!

you could have blown a fuse

Good question, I have a 98 and my drivers window will not work at all, and I can roll the rest up and down, but not the rear drivers, I can roll it down but you have to roll it up from the back seat.

get a cup of warm water, pour all over window,wipe it down, try again, it should work.

i would first check the fuses! and then replace switch 2nd! might try some w/d 40 in and one the switches you have before you replace them!

Your switch could be worn out you would have to replace the rocker to the switch or replace the whole window switch console.

roll down the window and look for a gas station if you run out of fuel

I felt dumb but I had the same problem, there was a WINDOW LOCK I had pushed, it is on the Drivers Door. My youngest son figured it out

If the mist is on the outside of the window, use windshield wipers, roll down window, or use rear de-fogger, depending which window has misted up. If the mist is on the inside, turn on the heat/AC, roll down window, or use rear de-fogger, depending which window has misted up.

When my back window would not roll down, I checked the rear window wiper assembly. The blade assembly needs to be down in a certain position before the window rolls down. Mine happened to be a little stuck up in between the window and the black insulation. Just wiggle the wiper down a little and try again.

Your problem isn't specific. Here is a list of causes. please refer this to identify the problem -

you can try WD-40 on window edges, but usually need to take off door panel and check the cable. I had this happen to 3 out of 4 windows and the motors were ok but had to replace the cable arm they are about $60.00

Check out the end of this video for details on where the motor rest is and how to perform the reset. Original Answer: The window motors 'window travel distance' can be reset by : (do not use auto-up or auto-down function) โ€ข open door so window does not touch anything but door โ€ข press and ***hold*** window button to roll window down and hold for at least 5 seconds beyond window full roll down โ€ข press and ***hold*** window button to roll window up and hold for at least 5 seconds beydon window roll roll up This will train your door motor on the limits of the window travel ====== It is the black button/nipple thing on the actual motor. It can be accesses by removing the door panel and then lifting the black sticker in the center of the door. best of luck

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.