0
How do you fix the stop lights of a 92 Lexus LS400 if the 2 attached to the body do not light up when you step on the brake but the two on the trunk are working and you replaced all the bulbs.?
Wiki User
∙ 18y ago
Need more information. Do the tailight bulbs light up, just not the brake lights? What about the turn signals? If so you might have the incorrect bulbs installed. If the tailights, turn signal and brake lights are out you have something disconnected. There are three bulbs on each side of the body part of the car. The top and bottom bulbs are dual bulbs (1157) while the middle bulb has one filament. It is probably the lamp failure sensor. It is located in the trunk on the driver side just behind the backseat. It is a small black box with a white connector connected in it. You shorted out the circuit board in the sensor. I repaired mine myself.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
What would make the stop lights quit working on a Lexus LS400?
poopin
Your 94 lesus ls400 rear fog lights are stuck on why?
Never known of a car to have fog lights in rear , only reverse lights
Causes for loss of power steering on 1991 Lexus LS400?
1992 Lexus ls400 no power steering replaced power steering rack because it was leaking but it had p/s.thought it was the rack so replaced agin no luck,replaced the p/s pump still no p/s.
What type of wheel alignment 97 Lexus ls400?
What is the problem when at idle I have hard steering? I just replaced the rack.
Is there a fuse for the dash lights of 1998 Lexus ls400?
Yes. See sources and related links for bulb info on this vehicle.
Why would the Radio stopped working in a 1998 Lexus es300 fuses not blown?
Radio in 1990 Lexus LS400 stopped working, possible answer?
What is the mostly cause of your 1992 Lexus LS400 showing a track off and check engine lights on dash?
I have heard a few different things mentioned. Check on lexusownersclub and post it in the LS400/430 catagory. A very good specialty site. vbd
Can you program ecu on 1993 Lexus ls400?
location of the ecu on 1993 Lexus LS400
How do you remove tensioner assembly 92 ls400?
How to remove auto tension 92 ls400
Is the fuel tank on a Lexus ls400 plastic or metal?
LS400 fuel tank is metal.
What do you do when the instrument panel goes dead after battery trouble I have seat belt light on and i can see the transmission lights - Park Drive Reverse - lights blinking.?
Toyota Avalon - 2001 - My battery died, and in the process of replacing it, the dashboard guages and information console stopped working, dead! I did a search on the Internet and found: "My 98 LS400 battery drained since i left the door open accidently and interior lights were on. I did a jumpstart and the car started and everything works except for the DASHBOARD. Everytime I start no action in the needles and no lights on Dashboard. I have seat belt light on and i can see the transmission lights (Park, Drive, Reverse) lights blinking. " The answer that was attached: I "had a similar problem on my 2000 Toyota Avalon and it was the battery. Instrument lights would not come on after some work on the car. If battery is OK, disconnect the negative lead and let system reboot. " I never thought I would need to reboot my car! Gotta love the Internet!!
What do you do when the instrument panel goes dead after battery trouble I have seat belt light on and i can see the transmission lights - Park Drive Reverse - lights blinking?
Toyota Avalon - 2001 - My battery died, and in the process of replacing it, the dashboard guages and information console stopped working, dead! I did a search on the internet and found: "My 98 LS400 battery drained since i left the door open accidently and interior lights were on. I did a jumpstart and the car started and everything works except for the DASHBOARD. Everytime I start no action in the needles and no lights on Dashboard. I have seat belt light on and i can see the transmission lights (Park, Drive, Reverse) lights blinking. " The answer that was attached: I "had a similar problem on my 2000 Toyota Avalon and it was the battery. Instrument lights would not come on after some work on the car. If battery is OK, disconnect the negative lead and let system reboot. " I never thought I would need to reboot my car! Gotta love the Internet!!
