more than likely u tryed to pry the sensore out with a screw driver,, next time turn and wiggle from sise to side and will pop out,,, u have to drop the oil pan,, either it fell to bottom or u stick ur hand up there and push back threw with ur finger,, i did the same thing..
i used oversiized pliers and a torch to heat a dry wall screw and pressed it into the sensor. after it melted around the screw i pulled it out!
where is the crankshaft sensor located on a 1988 cutlass supreme
The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.
Nee more info cutlass supreme or cutlass ceira which engine 3.1-- 3.8-- 3.3-- ????? Oldsmobile cutlass ceira 3.3 liteer engine
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6
where is the knock sensor located on 93 cutlass ciera
The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.
if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...
On front cover of engine by crankshaft pulley.
changing the crankshaft sensor
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
The Crankshaft sensor is located behind the Harmonic Balancer on the front-passenger side
Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L
The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.
The 1984 Cutlass is a model of car produced by the company Oldsmobile. The oxygen sensor is typically located near or on the engine block.
POSSIBLE CRANKSHAFT POSITION SENSOR.
it is located under the coils and ignition modual it is mounted under it all, it comes out with the modual, and be careful if it has been there a while you may break it,
i have a 90 cutlass ciera with a v6 3300 and just replased that. it is called a combanation sensor. its the crankshaft and cam together located at the back of the harmonic balancer attached to the block. it has 2 bolts on the right side holding it to the block a one in the middle to hold the sensor in place and the sensor sits in it and faces the harmonic balancer on the back of the interrupter rings
behind the harmonic balancer
The crankshaft sensor is in the front of the engine.Above the starter.You will have to drop the starter.2 15mm bolts.Look up and there it will be.
It should Be located on the top of the transmission.
The engine won't start.
it is right above the oill filter just to the left
Usually in your rectum. Depends on how deep you like it?
Behind the harmonic balancer (dampner) that is located behind the crankshaft pulley.