0
How do you get at the spool on Craftsman Model 358.799140 to replace line?
Wiki User
∙ 12y ago
assuming it is not a bump head replacement and the unit still has the original head.
1)remove old line
2)bend replacement line strip into a upside down U shape with even sides
3)insert into hole in glide plate
4)pull the line to remove slack in middle of U as even as possible on both sides
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change the spool on a craftsman bushwacker weed eater?
I can't seem to get the spool off.
Craftsman model 257.796050 need to know how torestring spool?
Read the owners manual in the link below. It will explain how to restring the trimmer.
Cant get the spool out of a craftsman line trimmer?
1. Rotate spool to line up arrows on spool and surrounding casing. 2. Find notch and pry with wide flat-end screwdriver. 3. Spool will pop out.
Looking for Craftsman 24 Volt Weed Wacker part number 71.74805?
Need full spool replacement
How do you fix a jammed weed wacker?
Stop motor. Remove line spool. pull spool from shaft and remove cord or weeds from around shaft. Replace spool on shaft. Re start motor.
How do you wind new weed eater string on an old spool?
pull straight out to remove the spool, wind in the direction of the arrow - to replace, feed the string through the hole and pull on it, keeping slight tension on the spool as you push it back into the head
Fuel line diagram for a craftsman 32cc weed wacker?
Mine had a guide hole that broke so I took a small piece of tubing for the fuel line and glued it inside the spool for a guide to start the line, end of line goes inside the guide and wraps around spool
How do you replace string on craftsman weedeater model 358.795550?
Unplug the weedeater from electrical source. Turn the weedeater upside down and remove the black knob on the bottom. If the black knob won't come off you can carefully use a large pipe wrench and turn it counter clockwise to loosen it. Be careful not to lose the slotted metal ring between the black knob and the trimmer spool. Remove the spool and clean it off. There is an arrow showing you where to insert the string. Start pushing the line into the spool going counter clock wise. Be sure to use only .065 ROUND string. Put the spool back on the spindle yellow side up. Hold the slotted metal ring with the slot facing up. Insert the string into the bottom of the ring and put the ring in the recessed circle on the spool, (yellow side). Pull the string over the slot and hold it there. Screw the black knob back onto the spindle, making sure the string is in the slot on the metal ring. Tighten the knob. You are now ready to go.
How do you reload a single string weedeater?
pop the spool out wind string in direction of arrow, replace
Need a spool cap for a task force battery operator weed whacker model 21023?
yes
How do you change wire on spool in window motor town and country?
You will have to replace the entire regulator assembly. The wire is not available.
What is a spool pin?
Spool pins are used on sewing machines to hold the spool of thread. Most or vertical, some that are horizontal use a spool cap to secure the spool of thread. Some machine come with spool nets to cover the spool to ensure the thread enter the machine evenly. Some machines come with an extra spool pin that fits into a small hole on the top of the machine to hold a second spool of thread.
