turn off your radio. hold in the tning button until a menu shows up on the display screen. using the next/ prev buttons on your radio, scroll over to oil life. press in the tuning button again and oil light should turn off.
What does trac off and abs light mean on a 2004 chevy impala
becaus the 2004 Chevy impala does not have automatic lights and they have to be turned off manually
My key Bork off in my trunk
I have a 2004 Impala SS. I currently have a aftermarket deck, the only other way to turn off the low tire pressure light is either 1) bringing it into the dealer, or 2) turn your key to the accessories position, turn your lights on and off three to five times, and it should have shut off your low tire pressure light.
my 05 Chevy impala brake light come on when my vehicle is turned off killing my battery.
possible the guy that did the oil change bumped a vaccum hose on the cruise control canister and broke it or knocked it off.
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
Turn the key to the on posistion. (Do not start the car). Press the gas pedal 3 times slowly and it should reset the light. I used to be able to reset it through the radio but I dont have the original one that came with the car.
If the dome light will not shut off on a 2002 impala, check for a water leak in the roof that might interfere with the operation of the light. Also check for a bad connection with the ground wire or a short in the wires.
With the car off, turn the key to the run position. Press the gas pedal to the floor 3 times . The car will chime and the Change Oil light will turn off.
Disconnect the red terminal on battery and let it sit for 15-30 minutes, reconnect the battery and check engine light should be off because the computer has been reset.
This is how to reset the "CHANGE OIL" light for a 96 Impala SS: 1. Turn the key to the "RUN" position with the engine OFF. 2. Push and release the gas pedal three times within five seconds. 3. Wait for the "CHANGE OIL" light to flash two times as a confirmation that the system has been successfully rest. If the "CHANGE OIL" light comes on and stays lit for five seconds, the system has NOT been reset. Therefore, you must repeat steps 1 & 2.