Mark driveshaft, yoke and splines so they are replaced at the same position to maintain factory balance.
Remove small "u" bolts at yoke
Pry driveshaft out of yoke and onto splines
Drop driveshaft and slide off splines
It depends on if it is two or four wheel drive, a 4x4 is 48 inches
about 36 inches w/ 5 sp manual
no unless it is a 4 wheel drive and you are in 4 hi or lo. I still wouldn't do it
auto parts store or sears
Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.
on the right side of pipe away from the drive shaft
Ford f150
f150 can a4 wheel drive wheel fit on a 2 wheel drive f150 both 6 bolt pattern
there is no drive shaft it's front wheel drive
approximately 4013 lbs.
the tail shaft of the tranny on the speedo cable
how do i remove the computer on a 1989 ford f-150