0
How do you get the instrument cluster out of a 1999 Saturn SL after all screws and bolts are loose?
Wiki User
∙ 17y ago
I assume the problem you are having is that the instrument cluster doesn't fit past the stearing wheel. The cluster has to be pulled out the front of the dash. First remove the bezel around the front of the cluster and then the 2 large bolts that hold up the steering colum must be removed and you can lower the wheel down onto the seat and pull the instrument cluster out towards the drivers seat. Another tip is that odometer is digital and it is common for it to look shattered or black if you are removing the factory black faces to install white ones. Don't panic when you plug the gauge back in it will return to normal.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you remove the cowling around the dashboard-instrument panel in a Toyota 94 previa?
You need to remove the cupholder*4 screws* and lower the cigaret lighter and cup holder underneath are two bolts,remove the two bolts.Remove the fuse cover and you will see four screws remove the two outer screws and pull out the radio unit and the vents. When you remove the radio cluster will show two screws holding instrument cluster bezel.Near the the door is a vent held by clips use a flat screwdriver to remove the vent.Just pull the instrument cluster bezel and it will come off.
How do you remove the instrument cluster on a 2003 Ford Crown Victoria?
Removal and Installation Remove the instrument cluster finish panel. Remove the lower steering column cover. Remove the lower steering column cover retaining bolts. Position the parking brake release aside and remove the lower steering column cover. Remove the retaining bolts and remove the lower steering column reinforcement. Position the transmission range indicator cable out of the way. Disconnect the cable.Remove the retaining screw and position the cable aside. Remove the instrument cluster screws and position the instrument cluster aside. Disconnect the electrical connecters and remove the instrument cluster. To install, reverse the removal procedure.
What is the procedure for removing the speedometer in a 1986 Fiero SE?
you can open the instrument cluster by removing the torx screws located on top and in front on the cluster panel--need to remove the cover under the steering column and drop the column for easier access to the wiring and other bolts holding the cluster in position
How do you remove the instrument cluster from a 1979 Jeep J 10?
Take out the guard around the steering column next to the dash(6 screws). Then the two bolts on either side of the column under the dash about an inch. Reach through the glove box and unscrew the speed wire. Then the 6 screws in the cluster. While holding down the steering column pull out the cluster (right side first, due to wiring).
How do you change a light bulb on the fuel gauge of a Ford Freestyle?
Remove 2 7mm bolts on instrument cover plastic. remove this part exposing the 4 7mm bolts that hold in the cluster then carefully remove instrument cluster from dash. On the back of the cluster you can remove the bulbs by turning them counter clockwise and pulling them out. Bulb number 194
How do you replace clock batteries on gsx1100f katana?
Remove mirrors, upper and lower faring. Remove four bolts that hold the instrument cluster. Remove screws that hold the black cluster face. On the back of the face is the clock. Remove all the small screws and open it being careful of the very small o-ring gasket. The batteries I took out were "Sony SR44SW, two of them.
How to dismantle dashboard in a 1994 Toyota pickup truck?
There are four Philips screws holding the upper dashboard to the car frame, loosen both and remove. Then remove the lower part, it is kept in place by six similar screws. Three of four screws at the top of the Instrument panel shroud should be removed. Remove the screws and the shroud. You will probably have to remove both the upper and lower dash covers. Then look for 4-5 screws holding the instrument cluster in. It may be necessary to loosen the steering column also, held in place by several bolts.
How do you replace instrument panel speedometer lights in a '98 Ford Taurus?
remove trim surrounding cluster, remove bolts securing cluster to dash, disconnect electrical connectors at cluster, twist failed bulbs out, reverse to install
How do you take out an instrument cluster in a 1996 Chrysler sebring jxi?
Pop out the bezel around the radio and note the 5/16 bolts (4 of 'em ) holding the main cluster bezel down. Remove the Fuse Access door on the driver side with the door open and remove the 5/16 screw just inside the access area. Remove them and GENTLY pull up on the assembly until it begins to pop out. The entire assembly should lift out from around the instrument cluster. Remove the 4 screws on the cluster (same size as the others) and lift the cluster. Lay the cluster down upside down and CAREFULLY unplug the cluster. One Blue, One Black connector. VIOLA! it's out. Replace in the reverse order.
What are the 3 things magnetic?
screws, bolts, and magnets
Do I need special bolts or screws for a used awning?
You do not need special bolts. Standard bolts and screws, as long as they are the correct size, can be used.
How do you replace the instrument panel lights on a 1988 Ford Taurus?
remove trim in front of cluster, then 4 7-8mm bolts that hold in cluster then shifter indicator from bottom of cluster hten pull cluster out until u can get behind to find bulbs, twist and remove the light bulbs likely be found at radio shack good luck
