Ok ive ideas but need to know what an LSC is REagrds
The oil filter on the 1998 MPV is on the side of the block. It screws on and is easily replaced.
1. Use 27mm socket and take off oil filter cap. Pull oil filter out. 2. Use 13mm socket and take out the oil plug. (7mm socket to take out small bolt holding the oil drain plug door in place). 3. Replace ring on oil filter cap with new one. Put oil filter inside cap (should snap in and hold in place) smooth end of filter down. Fresh oil around new ring then insert filter and cap. Tighten oil filter cap and torque at 25Nm or 19 lbs. 4. Replace oil drain plug bolt. Not sure on torque, just hand tighten (don't strip). 5. Fill with 5w40 Pennzoil Euro Type oil (a must as oil tolerances are tight and turbo uses engine oil to cool) 4 quarts. 6. Start vehicle for a few seconds to allow oil to work through oil filter. Turn off and check dip stick and for any leaks.
STP OIL FILTER S3675
If it is the same as a Greese Monkey L241, then it fits at least a 1998 Toyota Tacoma. Good Luck
Quaker State QS16 Oil Filter
Go to wal mart and buy a Fram Oil Filter Wrench......lol......i know it sounds dumb but that's the only way i got mine off
the oil filter is under the drivers side wheel arch, its easier to take the wheel off to get access to it that way you have no restrictions
The oil filter on the 1998 MPV is on the side of the block. It screws on and is easily replaced.
4.5 Quarts, with replacing the oil filter. Start, check, and top off as needed.
on my 94 it was near the oil filter and it was a canister type like your oil filter
No oil filter, the YZ125 is a 2 stroke.
The oil pressure sensor is on the oil filter housing just above the oil filter. It is about 1 1/2 inches long and points tword the front of the vehicle. It has a electrical connector plugged into the front of it. You have to take off the oil filter to get to it.
The oil filter may be lose.
There is an access in the cover below the radiator for the filter.
On my 1998 Taurus the oil filter is on the front towards the bottom.
take the filter off then unscrew the bolt at the oil filter housing
i have a '95 325I and the filter is located on front of the engine behind the fans, its in a cylinder looking thing. i needed a 14mm socket to get it off.