how to replace the power steering hose on a 2001 oldsmobile aurora 3.5 liter engine
On the steering wheel
I Do Not Know The Code But, I Do Know What Happens You Get A Mew Holding The Aurora Ticket Then Well Take The Aurora Ticket Out Of It's Hands Then There You Go! Have Fun With It!
To the left of the steering column under the dash.
The plastic cover around your 1996 Oldsmobile Are Aurora steering column is held in place with retaining clips. Pry outward on each retaining clip and the plastic cover will come off.
Turn signal switch.
Obd jack is located on the driver's side under the steering wheel you should be able to see it but 95 Oldsmobile Aurora is a transition year so OBD2 will not work it's obd1 certified
it is 40psi
The low pressure service port for the AC on a 1998 Olds Aurora is located on the side of the accumulator. It is at the back of the engine compartment, on the passenger side.
The flasher relay is located under the steering column support.
Just below the steering wheel inside the car, a little to the left.
There is a pin that goes in the side of the steering wheel. Take off the sterring wheel and cover. You should see a hole and the pin goes in there
A leaking fuel pressure regulator is the most common cause for a rich condition on the Olds Aurora 4.0L V8. -------------------------
Turn signal flasher is under the dashboard beside the steering column. Flasher unit for the emergency flashers is on the other side of the steering column.
It is located just under the dash on the drivers side near the steering column.
it is located above the gas pedal almost under the steering wheel
at the top of oil filter housing.
Against the firewall
When "low tire pressure" shows up hold down on the RESET for several seconds
Go to any game store that's holding the mystery event.
Is there spark at the plus? is there fuel pressure to the injectors?
Behind LH Side of I/P, Under Steering Column Brace, pn# 10041073
Change beltUse a 1/2" drive extension to release the belt tension. While holding the belt tensioner over take the belt off of the power steering pulley. After that just work the belt off of the remainder of the pulleys until you have it off. It is helpful to remove the inner fender to gain better access to the air conditioner pulley and crank pulley. to put the new belt on reverse the process putting the belt on the power steering pulley last while holding the belt tension over.