0
How do you hook up the oil lines on a sifton oil pump for a 60 panhead?
Wiki User
∙ 16y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Sifton oil pump?
Disassemble and clean the oil pump. Driver keys must be properly installed. Rotate gears that bend 180 degrees. Apply engine oil. Replace the check ball and install the opinion shaft gear. Connect the oil lines.
Sifton oil pump instructions?
Disassemble and clean the oil pump. Driver keys must be properly installed. Rotate gears that bend 180 degrees. Apply engine oil. Replace the check ball and install the opinion shaft gear. Connect the oil lines.
How do you replace a fuel pump on a 1989 Chevy s-10?
You will need to drop the gas tank, unhook the fuel lines, and replace the old fuel pump with a new one and hook back up the fuel lines.
How do you hook up hoses for water pump on 1977 115hp evinrude?
there are 2 plastic tubes covering the water pump lines in the lower unit.. slide the tubes down so about 1/2 inch is still on the lines, line the other ends up with the pump holes and they guide them right into the pump.
Where can you find Sifton oil pump installation instructions?
You should be able to obtain the oil pump installation instructions from the auto-parts store in which you bought the oil pump. The installation instructions can be found at most Harley-Davidson motorcycle dealerships.
How do you change the fuel pump on a 1968 Chevy Impala?
take the fuel lines off of the pump and take the 2 bolts out that hold it on and pull it off, to reinstall there is a pushrod inside the engine that rides on the pump arm, you have to push the rod back up out of the way and quickly insert the pump in place and reinstall the 2 bolts and then hook up your fuel lines to the pump and your done.
How do you hook up saltwater pump to an intex pool?
how do you hook up the cleaner to salt water pool pump
How do you change a fuel pump on a 1971 Plymouth Fury?
This is very easy. Jack up the front passenger side. Put a jackstand in the correct place. If this is a small block, the fuel pump is under the alternator. There are 2 bolts holding it to the block and 2 lines, 1 going into it, 1 going out. Un hook the lines (One will be rubber, it should be replaced). Then put the new pump in, and hook it all back up in the opposite order. Its pretty straightforward.
How to replace fuel pump 1965 mustang?
This one is pretty easy.. On the driver side lower front of the engine is the fuel pump, disconnect the lines, unbolt the pump and remove it. Clean the surface of the arear the pump was mounted to so the new gasket will seal properly, then bolt on the new pump and hook up the fuel line. ::AverageJoeResto.com::
Where is fuel pump on 1986 jeep commanche 4.0 liter?
it is located in the tank but you can get to it without dropping the tank. It is located top side..look for the fuel lines...and do you know how to hook up the vacuum lines on that same truck? or can you send me a picture of them?
How do you change a fuel pump on a 1971 fury?
take fuel lines off the pump and then remove the 2 bolts holding it on then pull it off, to install new pump there is a rod inside the engine that has to be pushed up while you slide the new pump in, I get a glob of grease and push the rod up and put a glob of grease on the bottom of the rod to hold it up in place so I can get the new pump in and get both bolts started and then tightened, re-hook fuel lines to new pump and your done.
How do you replace a power steering pump on a 2003 dodge ram 2500 with a 5.7 hemi?
From under the 2003 Ram, loosen the lowest power steering hose, and let the fluid drain into a pan. Remove the power steering belt. Remove the fluid lines, and unbolt the pump. Install the new pump, hook up the lines, and re install the belt. Fill up with new fluid.
