0
Disconnect Negative (-) battery cable from battery
Crawl under the passenger side of the truck just behind the right front wheel (if you are as thick as me in the middle the truck will need to be raised up, safely please.)
There are two (2) 15mm head bolts holding the starter to the engine block from below.
There are two or more wires attached to the starter, usually 8mm and 15 mm wrenches or sockets needed.
Undo wires
Unbolt and do not drop starter on your head (I have done this, ouch)
The wires may need to be undone with starter hanging loose
Reverse procedure for install.
Wiki User
∙ 13y ago
Wiki User
∙ 16y agothree bolts two wires its right next to your fly whell Positive battery cable goes to starter. Theres other wires, take note where they are attatched. Reinstall the way it was uninstalled.
Wiki User
∙ 16y agoI can explain in detail, Contact me in my message board and tell me what you know so far.
Wiki User
∙ 14y agoNeed to know what year and what engine to help you.
Add your answer:
Earn +20 pts
Why will 95 Chevy s-10 not start battery is new everything appears to power up fine but there is no clicking of the selinoid or starter?
check starter connection,if 12 volts there probably bad starter
Does a 350 Chevy and 327 Chevy take the same starter?
Sometimes. There are two common bolt patterns of Chevy starters, and two common flywheel diameters. Many blocks have both bolt patterns. If the starter bolts up to the block and engages the ring gear without binding, it fits.
2002 Chevy s10 turn key won't start change the ignition switch and tumbler still won't start sometimes won't say anything then other times starts right up?
If both ends of the positive and negative battery cables are clean and tight, the starter may be telling you it is on its way out.
Why the fuel pump of your Chevy pick-up S10 1995 still work after taking out the fuel pump relay?
Are you sure you pulled the right relay?
What years of Chevy s-10 truck parts are interchangeable with 1982 s10 truck?
i believe it is up to 86 maybe 88 that are the same truck.
Where is the horn located on a 98 Chevy s10?
How to hook the horn up
Chevy s10 1994 show me how to hook it up so it will work?
Hook up what? Need more info.
How do you hook up a starter on a 1984 Chevy beauvlle van w 305?
You can hook up the starter, on your 1984 Chevrolet, by attaching the ground cable and the hot cable to the appropriate posts on the starter. Bolt the starter into place.
Where can you find a used factory tape deck for a 1987 Chevy S10 Tahoe?
A great place is ebay.com or your local salvage yard should be able to hook you up!
Where is the starter located on a 1994 Chevy S-10 pickup?
On our 1995 Chevy S10 pick up, it's on the passenger side behind motor...looks kind of like a cylinder running lengthwise of the truck. On our 1995 Chevy S10 pick up, it's on the passenger side behind motor...looks kind of like a cylinder running lengthwise of the truck.
Where can you get a manual that shows how to replace the starter on an '84 Chevy S10 pick-up with a 2.0L engine?
get a haynes repair book any aid auto or auto zone has them
Where is the fuel pump located on a 1995 Chevy s10 pick up?
I have a 1992 Chevy S10 pick up and the fuel pump on my truck is inside the gas tank.
How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck?
How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck
2001 Chevy S10 Firing order on distributor?
firing order pick up s10 2001
Where to hook up the wires for a tach on a 1985 Chevrolet s10 blazer?
You should hook up the wires for a tach on a 1985 Chevrolet s10 blazer to the negative side of the coil. You should be sure to identify the positive and negative sides of the coil.Ê
How many wires hook up to a 1991 Chevy pickup starter?
There should be two on the large terminal and one on the small terminal I believe the small terminal is labeled S
How do you install a starter on 1998 Chevy S-10?
i just did a transmission change on a 90 s10 u probably have to drop gravel guard on transmission and starter should have two long bolts remove those and wiggle the starter out then carefully unbolt the two wires on the coil of the starter and be careful s10's usually have the two transmission lines in the way and those are a pain to replace hopes this helps and careful starter is heavy and u will prolly have to jack the vehicle up
