Want this question answered?
hay i am jitendra haldar can you Harmonic progression explane with examples
do the harmonic balancer have a seal for anti-freezer
The engine has a harmonic balancer on it, but if it is off, it is easy to re-install. Simply line up the key and tap it on most of the way and torque down the center bolt.
take off your harmonic balancer the answer is behind
First remove the old one using a puller that you screw into the harmonic balancer there is a key on it so you can not put the new one on wrong just use the bolt that holds the main pully on to push the balancer on
Not too familiar with that engine, but never use a hammer to press it on. Go to your local Kragen, Shucks or autozone, they have a harmonic balancer installer in which you can rent. It simply screws into the center of the shaft and evenly presses the harmonic balancer onto the crankshaft.
Remove the belt. Remove the bolt that attaches the harmonic balancer. Rent or purchase a harmonic balancer puller. Follow the Instructions with the puller and remove the old balancer. Install the new balancer making sure to line up the keyway, a little oil helps. Put the retaining bolt back in and tighten to manufacture specs.
first remove serpintine? fan belt then remove large bolt in middle of harmonic balance. this bolt usually has left hand thread next with a harmonic pulley ,puller, remove harmonic balancer.when removing this, there is a key in the balancer and shaft if a new key did not come with new balancer,make sure not to loose the old one install new balancer with key.use the bolt to pull balancer up tight where it needs to be and use proper torque on bolt
You will need a harmonic balancer puller. Remove crankshaft bolt and washer, reinstall bolt without the washer approximately 10 turns. This will protect the threads in the crankshaft. Install puller and remove balancer. You cannot remove the balancer without this puller. They are inexpensive or try to borrow one.
Not that I know of. I use a piece of threaded rod that fits into the crank along with a few heavy duty flat washers and a nut to draw the balancer in.
they make a harmonic balancer install/ remover....very simple with the right tool... more than likely any local parts store should have one on the shelf...they come with a decent diagram to help ya out
assuming the crank is out,cool it in the freezer and warm the balancer ,the balancer should slip on. be careful ! I have not done this with a crank and balancer,but it works well in other applications. ie.sleeves in blocks.