0
Well on a straight six you can remove the head after disconnecting all the manifolds (intake and exhaust) all the hoses (fuel,egr,etc.) valve cover and possibly interior engine cover. On v-8s engine R-n-R is porbably required. Vans can be a pain.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you change head gasket on Chevy Lumina?
You will need to remove the cylinder head from your Chevy Lumina engine. Remove the head gasket and clean the surface. Put the new head gasket on and return the cylinder had to its original position.
Will the head off a 292 Chevy 6 cylinder fit on a 235 Chevy engine?
no the inside of the head will be a different size
How do you repair a head gasket 1994 Chevy G20 van?
You will need to remove the cylinder head from your 1994 Chevy. Remove the head gasket and clean the surface. Put the new head gasket on and put the cylinder head back to its original position.
How do you install cylinder head bolts on a 1996 Saturn?
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
Is a 1966 427 Chevy cylinder head compatible with a 1967 Chevy 396 block?
yes
How do you remove the head from a 99 Chevy Cavalier 4-cylinder?
unbolt it
Do you use silicone on Chevy 350 cylinder heads?
Not on the head gaskets.
Where is the Master clutch cylinder 1995 Chevy truck?
on tims HEAD
How do you remove the heads on a Chevy 350?
take out the cylinder head bolts
1.6 liter Chevy aveo cylinder head torque specs?
2004 chevy aveo 1.6 head bolt torque specs
Installing cylinder head temperature sensor on f-250?
To install a cylinder head temperature sensor on a F-250, you disconnect the cylinder head sensor from the electrical connector at the rear of the cylinder head. When installing the new one, you reverse the process of removal. The cylinder head temperature sensor is located by the O2 sensor.
What are the torque spec for the head for 2001 Chevy cavalier 2.2?
The 2001 Chevy Cavalier 2.2 liter engine cylinder head bolt?ætorque specification is 120 pounds. The cylinder head bolts should be torqued in 40 pound intervals.
