I installed a light assembly off the lamp assembly wire under the radio, as I could not find a bulb receptacle for the S\HVAC controls. The upper light I could not make bright enough, the one on the top of the console. I tried a 11 watt 12 V bulb and was still too dim to see the controls. Rpb, 1980 Corvette owner
You will need to remove the center console cover. The lightbulb will be attached to the inside of the center console. Push the lightbulb in and turn at the same time to remove it. Reverse the process to install the new lightbulb.
I do not beleive your jeep uses bulbs in the console. I have a 2000 grand cherokee and it uses a light strip that is part of the console and can only be replaced with the shifter assembly....... I plan to cut the wires from the light strip and install a pep boys console light that uses replacable bulbs....probably will just lay it in there as long as it is protected and safe... Good luck
The shifter light on the center console of a 1999 Honda Civic can be reached by removing the center console assembly. Loosen all of the proper screws and pull off the assembly. Once the bulb is visible replace the unit using an appropriate sized bulb.
Toyota Camry 1999 model - replacement of interior console light
If it's a 4-spd the switch will be mounted on the side of the transmission. If the car is an automatic...There is a combination "neutral safety-backup light" switch located under the center console on the passenger side.
Remove the shifting console cover. Remove the shifting light retaining ring. Push the light bulb in and turn at the same time. The light bulb will come out. Reverse the process install the new light bulb.
Begin by removing the 2002 Jeep Liberty shift console retaining bolts. Lift the shift console up and the light bulb will be visible. Take hold of the light bulb, push in and turn at the same time to remove it. Reverse the process to install your new shift console light bulb.
The center brake light replacement will require replacing the entire brake light assembly. Remove the wiring harness. Remove the center brake light retaining screws. Reverse the process to install the new center brake light.
The answer for this question can be found here: http://www.2carpros.com/forum/1998-volvo-v70--center-console-vt162248.html
== == how do you reset the oil light on a1992 corvette
No. It has a unlit reference. The illuminated selector in on the center dash.
it's a function of the shift-position sensor switch (automatic) which is in the center console.