answersLogoWhite

0


Best Answer

You must have cruise control. The lower cable comes up from the transmission and fastens to the transducer. A shorter cable goes from there, through the firewall, and into the car. It slides on to the back of the speedo head and clips into place. The connections outside the car are pretty straightforward, there are nuts that you unscrew. Behind the dash is abit tricky if you have big hands. There is a locking device that you have to push with a finger while you grasp and pull the cable with the other hand. Match the new cables to the old ones before you install them. On the new cables pull out the inner drive cable and check that it has some light grease on it. Some come lubed, some don't. Also, put a little oil into the "bell" end of the short cable. This is the end that goes on to the speedo head. If you are successful at this go get yourself a steak dinner.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you install the speedometer cables lower and upper on a 1982 corvette?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove and install upper and lower speedometer cables on a 1982 Datsun 280zx?

pull the dash apart. behind the speedometer you will see the cable. it connects to the transmission.


What is the knob below the speedometer in the lower part of the dash do on a 1977 Corvette?

resets the odometer


Why does your 1981 corvette speedometer jump at low speeds?

check the speedo cable and see if it needs to be lubed. if car has cruise control, it will have a upper and lower cable.


How do you change the battery in a 1997 Ford Thunderbird?

disconnect the 97 Thunderbirds battery cables. Find the battery hold down and remove it. Lift the battery out, then lower the new one in. Install the clamp and hook up the cables.


Your speedometer for your 1978 corvette is not working-do you have to replace both the upper and lower cables?

First I would remove the lower one, it's the easiest. Once out, reach inside one end and pull the inner rod out as far as possible. then attach a drill on the other end and turn it on. If both ends turn at the same speed then it's probably ok. If you can hold the end opposite the drill without it turning then it's broken. Use the same method on the upper cable.


Battery removal 1981 Corvette?

Open hatch behind drivers seat......remove battery cables.....remove battery hold down clamp at lower back flange of battery...pull out battery....replace in reverse order.


Where is the fuse box on a 1968 Corvette?

The 1968 corvette fuse panel is under the drivers lower left side of the dash .


Where is the spare tire for a 1987 Corvette and the jack.?

Where is the spare tire located on a 1987 Corvette? Under the back of the car below the CORVETTE, use the lug wrench to lower it the jack is on top of the tire.


Where is the starter located on a 1973 corvette?

Lower rear end of the engine On the passenger's side lower rear of engine.


How do you install upper and lower bushing in 1976 corvette?

Mines a 77. Had to drill out the mounting studs and install new with supplied bolts. Simple once the original mounting hardware is drilled out. Start with a small bit and drill as directly thru the center as possible. Follow with a larger bit, finish with a grinder.


What is the base price for a Chevrolet Corvette?

The approximate base price for a Chevrolet Corvette is $54,600. And that is for a new 2013 Chevrolet Corvette. If you were to try an older one then you might be able to find a lower price for one.


What places sell a C3 Corvette?

There are many dealerships across America that sell C3 Corvette's. One of the best places to buy a C3 Corvette is directly from a Corvette dealership. Many used car dealerships sell C3 Corvettes at a lower price.