You pry it over enough to remove the belt.
You loosen the tensioner pulley bolt and thread the adjuster bolt backwards on a 4.0L.
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
If it
Ajustment bolt is located at the bottom of power steering pump.
To loosen the tension on a serpentine belt on a 2005 Grand Caravan 3.8L, turn the nut of the belt tension pulley to loosen it. Adjust the belt, then tighten the tension pulley by turning the nut in the opposite direction.
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
A ratchet isÊneeded to loosen the serpentine belt tension pulley on a 2002 Jeep Wrangler V6. It will require a 1/2 inch ratchet.
Looks like you have to loosen the tension on the serpentine belt first. Only one bolt is not easily accessed. If you don't loosen the belt, you have to hold the belt out the way (with tension on it) and try to get the bolt in and hold the housing up at the same time (good luck with that unless you have three hands), it can be done though. I am not much of a mechanic and it took me about 1.5 hours with the serpentine belt in place.
You could do what I did, wait for the tension pulley to fall off the van...
If it is a drive belt and not a serpentine belt is has no tensioner. You manually adjust the tension by normally adjusting tension by moving the alternator. Loosen to bolts holding the alternator in place and then adjust the tension. Tighten the bolts when the tension is right. If it is serpentine belt if you follow the belt around the the engine you will see the tensioner.
Changing the serpentine belt on a 97 Mitsubishi Diamante is a fairly easy task. All you need to do is get a wrench and loosen the tension pulley and pull of the serpentine belt.
the idler pully makes the tension. to remove belt you use a wrench push tensioner in a direction that would loosen the belt as if you were trying to tighten or loosen the bolt holding the pulley on. carefull high tension.
the Serpentine Belt on the 91 Lebaron is on Tension Pulley, you dont tighten it. But if it is loose and you need to tighten it you just go and buy a new belt and put that on.