Want this question answered?
You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.
You have to get a stering wheel puller.. Take it off.. Pop it out and put the new one in like you took the old one out..
generally, the ignition switch is where u put the key
yes
Just put in
It's all part of the ignition switch assembly. The "Click" is usually the steering wheel lock pin dropping into place.
The ignition lock is where you put the key. The ignition switch is located on the top of the steering column directly above the brake pedal.
how long does it take to put a water pump in a 2002 gm sierra truck
There may be a loose or broken wire in the ignition switch. The wire is the one that leads from the ignition switch to the starter solenoid/relay.
replace it
If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.
how do you replace the ignition switch on a 97 gmc sierra 4.3 ltr. c1500 v6? I read this on Wikipiedia and did not believe it until I did it. My ignition stuck, key would not turn, had to have it towed home. Before I stated to tear it apart, I check to see if anyone had a run down on taking the tumbler out. I read a few and then spotted this one that said, "put you key in the ignition and whack it hard with a small two by four". I though, what the hell, it's going to take 3 hours to pull all this stuff out and to put it back, why not? Went out to the truck with all my tools and a small two by four. Stuck the key in the ignition, smacked it hard three or four times. It turn like a dream. I want to add that I had sprayed WD 40 into the lock about 6 hours before. It seems that it helps the key pins drop back into place.