you start by loosening the tension pulley that's actually hooked to the alternator(right off the top bolt), once this is loosened, you can move the alternator back to where the belt fits and tighten it back up and your done
have take motor and trans out 1996 Honda accord put timing belt
I had a hard time with it, I took the power steering pump off then lossened the alternator to get to it. That is on a 1990 model by the way and I would think they are the same,
The alternator belt on a 1998 Honda Civic is replaced by loosening the mounting bracket, disconnecting the wiring harness, and slipping the belt off the pulley. The alternator is then unbolted, removed, and a new unit put in place.
around 14-14.5 volts
Paraphrasing from the service manual: 1. disconnect the battery. 2. Remove the cooling fan next to the alternator. 3. Put a wrench on the idler pulley and move it to the rear to lessen the belt tension. Remove belt. 4. Remove alternator connections 5. unbolt alternator plus one bolt holding a wire.
When Honda designed their V-6 engine they did not repeat one of the worst mistakes they made on the inline 4. On an inline 4 Honda, the alternator is stuffed between the engine and the firewall and you need to take apart half the front end to get to it. The alternator on a V-6 Honda is between the engine and radiator - very easy to get to. So...you unhook the battery, loosen the two bolts that hold the alternator in, pivot the alternator to loosen the belt, remove the wiring to the alternator, remove the two bolts, lift out the alternator...if the new alternator doesn't have a pulley move the pulley from old to new, then bolt it in leaving the two bolts loose for now, hook up the wiring, put the belt back on, adjust belt tension and tighten everything down good before reconnecting the battery.
I just did this on my '99 Honda Accord EX so assuming it's the same as a 2000... put a wrench on the 14mm hex head bolt on the tensioner pulley and turn counter clock wise, this rotates the tensioner releasing tension on the belt . I found it easiest to have someone under the car pulling the belt off the bottom pulley (crank) while someone releases the tension.
Loosen the alternator tensioner bolt. The alternator belt will become loose. Remove the alternator belt. Put the new alternator belt on and reverse the process.
How do i put in the anti thief code in Honda 2006 accord?
About 2 hours if you are a professional and have done it many times.
how to put in a ignition on a Honda accord 1991
Yes.