depen the car and model .Cadillac deville 95 has an small triger on top closer to puller cable. all you need , is pull.
Take out the hand brake and replace it
my parking brake release did not take off the parking brake on my 2001 chevy s10? is there a way to disengage it?
Parking brake will not release even manual will not work on 1994 cadillac deville
wd-40 and a hammer
A stock emergency brake, on a Chevrolet truck, can be released by manually disengaging the emergency brake. This can be accomplished by loosening the tension nut on the brake.
Sticky or stuck brake caliper. In some cases a damaged brake hose can do that also.
Check the brake switch on the brake pedal, if the switch is bad or a fuse is blown, the shifter will not release.
I'm assuming by park brake you're talking about the emergency brake system, there is usually a 'pin' type setup underneath the vehicle where the brake handle is above it which can be pulled out that will 'release' the brake. Have a look under it.
I use to have a 440c. Do you mean the emergency brake is stuck ? Like the brake pads are stuck in the lock position on the brake disk on the driveline. Something must be froze up or the cable is broke or way to loose to work the brake.
it sounds to me that your hand brake is applied or stuck on.try releasing it or check the rear brakes.
Build up air, chock the wheels, release the brakes, and hammer on the brake drums.
A stuck parking brake could be caused by several things. The brake cable that operates that brake could be stuck, or the mechanism could be stuck at the wheel. The wheel will need to be removed and the cable and emergency brake arms will have to be checked.