Want this question answered?
NO.
first remove serpintine? fan belt then remove large bolt in middle of harmonic balance. this bolt usually has left hand thread next with a harmonic pulley ,puller, remove harmonic balancer.when removing this, there is a key in the balancer and shaft if a new key did not come with new balancer,make sure not to loose the old one install new balancer with key.use the bolt to pull balancer up tight where it needs to be and use proper torque on bolt
you should use a tool called a harmonic balance puller. the balancer came off in two pieces and the second piece that's still on the crank shaft won't come off
Not recommended.
If it has a 350 Vortec engine, then it is on the left bottom side of the timing cover behind the harmonic balancer. If it has the genaration II engine then it is behind the starter. You will need to remove the starter to be able to see it.
yes.
It should be 8 inch
yes
YES, It is bolted in the lower passenger side of the timing cover behind the harmonic balancer It is held in place with 1 10mm bolt
Yes.
60 ft-lbs
Yes.