is it a pintara
The idler pulley is mounted on a plate that needs to be removed. In order to remove the plate with the idler pulley, you must remove the engine mount to get out the idler pulley. To remove the engine mount, you need to jack-up the engine from the bottom of the oil pan (Note: place a piece of wood plank between the bottom of the oil pan and the jack). The idler pulley is mounted on a plate that needs to be removed. In order to remove the plate with the idler pulley, you must remove the engine mount to get out the idler pulley. To remove the engine mount, you need to jack-up the engine from the bottom of the oil pan (Note: place a piece of wood plank between the bottom of the oil pan and the jack).
Remove the belt, then remove the bolt holding in the idler pulley.
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
To replace the belt on a Nissan Frontier, first loosen the idler pulley of the belt and remove the bolts. Then slip the replacement belt onto the pulley and put back the bolts.
Remove the old, damaged idler pulley and replace it with a new one.
The idler pulley on a 2003 Nissan Sentra 1.8 is changed by removing the engine accessories, removing the drive belts, and loosening the retaining bolt. The pulley can then be removed from the vehicle and a new one bolted into place.
Remove serpentine belt. Remove pulley. Install new pulley. Install serpentine belt.
Should only be one bolt in the middle of the pulley that releases it.
The idler tensioner pulley on your 1999 Ford F3 50 pickup truck is held in place with a single retaining bolt. The retaining bolt will go through the middle of the pulley. Tighten the retaining bolt to install the tensioner pulley.
Remove belt. Remove the bolt and then pull the pulley off. Put new pulley in position. Put the belt back on.
remove belts idler is to close to fire wall to come off after you remove nut.jack up car and put stands under.how put a jack under engine . remove top motor mount bolt and jack engine up this will give you the room to change idler pully.
Remove your idler pulley first. it is the pulley right next to the alternator.