Want this question answered?
Get a very good mechanic and dont plan on getting your car back the same day. Or buy a new gasket and remove the intake and diy.
The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.
You will have to remove the intake manifold and install a new intake gasket. You have no choice.
The intake and exhaust manifolds, along with the timing belt will have to be removed to gain access to the head. Remove the head and replace the gasket. Torque the bolts down to the manufacturer specs and in the order Nissan suggests.
Remove the intake manifold retaining bolts from your 1993 Mercedes-Benz manifold. Remove the old manifold gasket. Clean the surface and put the new gasket on.
Remove the intake manifold retaining bolts from your 1996 Chevy Astro Van. Remove the manifold gasket and clean the surface. Reverse the process to install the new intake manifold gasket.
Repairing intake gasket not preferred, you can use red silicone to seal it, but to do so, you must remove the intake, in which case, you may as well replace the gasket.
Remove the 1995 Oldsmobile Cutlass intake manifold retaining bolts. The manifold will come off. Remove the old gasket. Clean the surface. Put the new intake gasket and tighten the intake manifold retaining bolts.
is it a pintara
the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!
Yes, remove the intake manifold and replace the gasket. It can be done with a basic mechanics tool kit.
Pretty straight forward. You must remove the intake manifold in order to replace the gasket.