pull out the u-shaped hook that holds it in. it faces the dash. you might have to put the gear into 1st or 2nd to have enought room.
take it to a mechanic
You remove your Water pump after that you'll figer it out
i just had to replace the shift solenoid on my 96 z28. if you drop the trans pan you will see both of them side by sidy they have two wires running to each of them.
The exact firing for a 96 Chevy Camaro 3.8 RS is 96 hp.
ON MY 96 ACCORD I PULL THE BOOT DOWN (IT HAS A CLIP) THEN TURN THE KNOB COUNTER CLOCK WISE. wHEN YOU GET A NEW ONE YOU JUST SLIP IT ON AND IT SHOULD COME WITH SCREWS TO TIGHTEN IT UP. Jose
Yes.
Yes
you do not need to remove the governor off the camaro because the 89's do not have them. they didn't start puting governors on cars until 96.
its not screwed in. Just pull it out as hard as you can.
Remove the engine and drive shaft
Where is the evap purge control valve located on a 96 camaro
Yes