Want this question answered?
Loosen the 18mm bolt about 4 or 5 mm and give the bolt a good wack and the pulley should pop. Then remove the bolt and pulley.
1998 Nissan pathfinder crankshaft pulley bolt is right handed.
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
remove center bolt and use the required puller
Counter clockwise
The crankshaft spins counter-clockwise on a 1997 Honda. To remove the bolt for the main pulley spin the bolt clockwise.
Remove bolt, and use a harmonic puller to remove pulley.
Remove belt, remove crankshaft bolt with air impact tool, remove balancer pulley with a balancer puller. Then you will be able to get to it.
The crankshaft has four 8mm bolts that hold the pulley onto the camdrive pulley.Do not remove the large bolt in the center unless you are going to replace the crankshaft seal.Also be sure to tighten that bolt if removed, it will walk back and forth and damage the crank eventually.
put the car in drive and crankshaft wont turn anymore. then you can take off the bolt
Undo the crankshaft pulley bolt { anti clockwise } Then you will need a good strong puller to remove it. or try to move it by tapping the back of if fairly hard until it comes off.