you have to replace the whole module if I am not mistaken, first remove the steering wheel cover and then there should be 2 pins you will have to get to and push simultaneously to remove
On newer Sportsters the module is located under the battery. You have to remove the battery then pull up on the rectangular cover of the module on the bottom of the battery tray.
It is inside of the wiper motor. Remove the 2 or 3 screews that's on the black cover that's on the front of the wiper motor and unplug the electrical connector. Remove the cover and then pull the module board out. Real easy no problem.
At the front of the engine, behind a plastic cover, just above the exhaust manifold. There are 4 clips that hold the cover to the ignition module. Under the cover, there are 2 bolts that secure the ignition module to the engine. Disconnect the wiring plug on the end of the ignition module. Undo the bolts and use them to extract the module, then remove the plugs as normal.
I have a '95 grand am quad 4, 2.3 liter engine. The 2.3 quad 4 engine has the spark plugs underneath the ignition module cover, which is the cover that has "Quad 4" written on it. You have to remove this cover to get to the spark plugs. To remove the cover, you have to first unplug the negative batter cable and then unplug the crankshaft sensor from the ignition module housing. The cranshaft sensor is the plug that is to the top right of the ignition module housing. After you have unplugged the sensor, you have to unscrew the four bolts that are on top of the ignition module cover. After you've done that, you can lift the cover directly up. This disconnects it from the spark plugs. When purchasing new spark plugs, make sure you get the right ones for the engine, adn you can ask the guys at the shop to set the correct gap for you.
The easiest way to bypass the theft deterrent module is to remove the fuse. The location of the fuse can be found on the inside cover of the fuse box.
The easiest way to bypass the antitheft module in your 1997 Buick Skylark is to remove the fuse. The location of the antitheft module fuse is listed on the inside cover of the fuse box.
How do you remove the brake light cover on a ford focus
Inside the wiper motor. Easy to change without removing the wiper motor. Unplug the harness connected to the wiper motor, remove the three small screws that hold a black plastic cover on the front of the wiper motor, remove the cover, remove the pulse board. The pulse board is available from your local auto parts store.
The only way to change the plugs is to remove the top cover first. Then remove the cover for each plug.
Remove the plastic cover behind the battery, and you should find it. Small black module.
i am going to change the valve cover gasket on my 97 cadillac catera, what do i need to remove and do? Is it hard?