I just removed the drivers side panel the other day. There are 3 torques type screws on the bottom of the panel and 2 on the handle. I didn't realize they were there at first, not until I noticed the panel pulling away on the sides and not the center. Anyway, you must remove the handle cover to access the 2 screws. Simply pry it out, it just pops inplace with clips. Once you have the all the screws out, lift up slightly on the panel to clear it of the window trim and lock rod now pull it back and disconnect all the wires and door latch cable and you are done. Removing the speakers is a different animal all together. I hope this was some help.
How do you remove the driver side door panel of a 1998 VW Beetle to replace the door handle cable?
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.
you have to remove the door panel
In order to replace the speakers you have to flip down the rear seats and look at the screw ports and remove all the screws to remove the panel covering the speakers. The rest is self explanatory.
You have to remove the door panel, after that you will be able to replace the speaker.
Yes the door panel must be removed to gain access to the speakers. Just replace them It will sound better.
power door or manual
# Remove the door trim panel # Remove the mounting screws withdraw the speaker unplug the electrical connector and remove the speaker
link here: http://www.craigcentral.com/durango/speakers.asp